How to install the hook?
Prefer to read? The whole thing step by step — no special skills needed. The hook slides onto two screws and locks in place.
Hold the wooden template level against the wall. Mark a dot through each of the two slots with a pencil.
Drill at both marks with the 6 mm bit. Soft walls (plasterboard, wood): the screwdriver can do it. Go slow.
Put a plug into each hole and tap it in with the hammer until it sits flush with the wall.
Drive a screw partway into each plug — don't tighten fully yet. Leave the heads standing out.
Hang the template over both screws and tighten until the heads press against it — its 2 mm (1/16″) thickness sets the exact depth.
Slide it off sideways — the heads now stand exactly 2 mm out: the gap your hook needs.
Put the keyhole slots over the screw heads and slide the hook down until it latches snugly. Gentle pull to check — done.
One mount — nearly all our hooks
The keyhole mount you've just used is our universal wall system — proven over the years and refined so hanging things stays this simple. Almost every hook we make goes up exactly the same way: once you've installed one, you've installed them all.
That's it — enjoy your hook.
Something missing or not quite right? Message us and we'll help you sort it.